PROCEDURE
The procedure:
Step 1:
Clip one twist off the D. 3x 5 cm D, 4x 5.5 cm D and 3x 6 cm D for the necklace. 2 of each twist for the earrings.
Step 2:
Grip the D in the middle of the twist with the flat nose pliers and bend it.
Step 3:
String the TC on one side of the D; 20x TC on the 5 cm D, 25x TC on the 5.5 cm D and 30x TC on the 6 cm D. Snip off the D and create a loop. Leave an overhang of about 1 cm of the D. The loops are turned towards one another. Grasp the end of the D between the rounded points of the needle nose pliers. Start twisting the D around the point. You can shift the points when creating the loops. Once the loop has been completed, grasp the D behind the TC and twist it so that the loop is centrally located above the TC. You can close the loop by pressing it with the flat nose pliers.
Step 4:
Create the second side of the D.
The necklace
Step 5:
Cut off 6 lengths of 1.5 - 2 cm from the thin chain. The end links must be facing the same way. Cut off 2 side chains of about 30 cm; they are doubled. Subsequently adjust the length.
Step 6:
Start connecting the necklace from the middle. Open an 8 mm ring. String a 6 cm D loop, both 5 cm D loops and the second 6 cm D loop. Thread the outer links of the two short chains.
Step 7:
String an R3 onto the chain. Thread the ring through the outer link. String both 5.5 cm D loops. Add another chain.
Step 8:
Link the D loops and the chains in the same way as in the middle. Don't forget the R3. Also connect the outer 5.5 cm D loops and one chain.
Step 9:
Also connect the second side of the necklace.
Step 10:
Thread the long side chains into the outer 8 mm rings. String an R3 on both ends of the chain on one side. If that is not possible, then only do it on one end.
Step 11:
Adjust the overall length of the necklace. The pattern has a length of 40 cm when fastened. Prepare about 7 cm of adjusting chain. Connect an R3 strung on a 10 mm ring on one side. Connect both ends of the chain from one side of the necklace using a 4 mm ring. Add the adjusting chain. Close the rings. Attach the carabiner on the ring on the other side.
The earrings
Step 12:
Prepare the earring hooks. Remove the spring and the ball from the hook. String a R6 and return the spring.
Step 13:
Connect the 6 cm and 5 cm D with a 8 mm ring. String the 5.5 cm D between the 6 cm and 5 cm D. Thread the 5.5 cm D loop through the new 8 mm ring, the ring from the connected wires and the second 5.5 cm D loop. Add the loop from the earring hook. Close the ring.