PROCEDURE
The procedure:
A bracelet made on memory wire
Make a loop on one end of the memory wire. Grip the end of the wire between the points of the rounded pliers. Twist it around the pliers' points. Then carefully move it back so that it is centrally located above the continuation of the wire. String the seed bead mix from the second side. Leave about 1 cm of free wire after stringing all the beads and cut off the remainder. Create a second loop at the other end. String a bead onto an eye pin. Shorten the pin's excess length to about 1 cm. Create loops. Hang them on the loops in the memory wire.
A multi-rowed bracelet
Step 1:
First create a large loop in the thread near the needle. Cut off about 15 cm of regular cobbler's thread and thread it through the eye of the needle. Tie the ends of the thread.
Pass the cobbler's thread through this loop. String 3x 15 cm of seed beads of the same color on the doubled thread. Connect all three strung threads with a knot and cut it off ca 0.5 cm from the knot.
Step 2:
String 3x 21-23 cm of a bead mixture. Tie the ends of the threads together with a knot, while leaving ca 3 cm free after the knot. Tie them together and hang them so that you can plait the ends of the thread and the seed beads together. Plait 15 cm. Remove any remaining unused seed beads and join the remainder of the thread with a knot. Shorten the end of the thread at both ends to ca 0.5 cm.
Step 3:
Cut off two colored cords (17 cm) and glue them into the prepared cups along with the previous stringings. Let the glue dry properly. You can connect two beads in the same color as the seed beads at the end of the chain.
