Floral Bracelet

Difficulty: 2
Technique: Stringing, Basic Beadweaving

Bracelet made of beads and seed beads from the PRECIOSA Traditional Czech Beads™ brand

Floral motifs are still current. Preciosa Ornela presents a tutorial on how to assemble a floral bracelet from the popular PRECIOSA Pip™ and PRECIOSA Pellet™ beads. Be inspired and create your own floral accessory. Choose suitable colors from the wide range of beads and seed beads sold under the PRECIOSA Traditional Czech Beads™ brand. 

Ambassadors

Hana Černá

"I work with beads, therefore I am." The Czech designer Hana Černá, nicknamed Hanule, works with beads and seed beads because she loves being creative. She also teaches others who share her enthusiasm and she does it all with her own type of blacker than black humour. She established the Beads on Facebook (Korálek na Facebooku) group which provides inspiration, encouragement and advice in the area of beadworking.

Learn More

Materials & Tools

Tools

You can also use PRECIOSA Thorn™ beads in the same color as the PRECIOSA Pellet™ for additional decorations.

Rings for finishing; a carabiner; Nymo thread or a line; a needle; scissors; pliers

Procedure

Step 1

Thread the needle. String 10x R10, 1x Pl and 10x R10. Thread the needle through the PI. A loop of R10 will be created, on which you will attach the fastening. Do not forget to tighten the thread when working.

1

Step 2

String 3x P and once again thread the needle through the Pl in the same direction from the loop to the rocailles.

2

Step 3

String 3x P again and thread the needle through the Pl so that a flower is created.

3

Step 4

Thread the needle through the following 10x R10, tie the ends and continue with the work. String 1x Pl, 3x P and thread the needle back through the Pl. 

4

Step 5

String 3x P and thread the needle through the Pl. You have created another flower. String 10x R10.

5

Step 6

String 1x Pl and 3x P again and thread the needle back through Pl. Repeat the procedure according to figures 5 and 6 until you have the required length of the bracelet.

6

Step 7

After achieving the required length of the bracelet, string 10x R10 and thread the needle back through the Pl. This will create a loop for the fastening. Sew the thread in firmly and tie several knots. Cut off the thread.

7

Step 8

Finishing

Use the flat nose pliers to attach the fastening – the ring and the carabiner. You can use Th beads to additionally decorate the end of the bracelet with the rings.

8 / a

Downloads