Precious ring

Difficulty: 3
Technique: sewing

Ring made from PRECIOSA Twin™, PRECIOSA Solo™ and PRECIOSA Candy™

The beads from the PRECIOSA Traditional Czech Beads™ brand can be excellently combined. You can try this out using this new tutorial for a ring designed by Helena Chmelíková.
You will need the PRECIOSA Twin™ Seed Bead or pressed bead and the PRECIOSA Solo™ Pressed Bead, as you will make use of their identical size and shape and sew around them with the 12 mm PRECIOSA Candy™ cabochon.

Ambassadors

Helena Chmelíková

She is able to switch from luxurious and extravagant fashion show pieces to the preparation of hobby projects,

Learn More

The brown variant

Materials and Tools

A ring with a face with a diameter of 20 mm;
0.20 mm nylon line; a thin sewing needle; scissors; hot melt glue with a pistol; flat nose pliers (for flattening the end of the line)

Procedure

Step 1

The circle

String 24x T (fig. no. 1a + 1b). Tie them off (fig. no. 1c). Flip the T alternately upwards and downwards. Thread the short end of the line through the nearest holes. Thread it through about 3 T. Continue sewing on the opposite side (fig. no. 1d).

1 / a

Step 2

Thread the line through the second hole in the T (fig. no. 2a + 2b). String 1x R10 in the gaps between the T (fig. nos. 2c + 2d). Thread the line through the T up to the free hole in the lower T (fig. no. 2e).

2 / a

Step 3

String 2x S into the gaps between the lower T (fig. nos. 3a + 3b + 3c).

3 / a

Step 4

Thread the line through the upper hole of the joining T. Thread the line through one of holes in the C, place it in the groove (fig. no. 4a + 4b). Thread the line through the opposite gap between the T (fig. no. 4c). Turn the circle face down. Thread the line through the gap between the upper T. Go back to the same hole in the C. Place the line in the slot between the two T. Thread the line through the gaps between the T at the starting point in the same way. Once again, thread the line through the same hole in the C. Thread the line throughthe opposite gap one more time. Once again, thread the line through the same hole in the C. Now, go to the second hole in the C. Sew through the gaps between the T in the same way, 2x on both sides. Sew the line in. Place the knot on the line in the direction from the slot between the two T. Pull the knot into the holes in the C (fig. no. 4d).

4 / a

Step 5

Apply the hot glue onto the face of the ring (fig. no. 5a + 5b). Press the back of the circle onto the ring. Centre the circle on the face (fig. no. 5c).

5 / a

Downloads